The 60 rpm dc motor manufacturer tells you that in order to speed up the production efficiency of the product, the DC gear motor is often in a state of overloading, which may cause certain damage to the equipment for a long time. Motor overload is a state of overloading. The specific reasons Generally as follows, let us 60 rpm dc motor manufacturers tell you to learn about it together:

1. Improper selection of the motor, the actual use of the load conditions does not match the form of the selected submersible pump; the selected lift is too high or too low.
2. The 60 rpm dc motor manufacturer tells you that the power supply voltage is too low, the motor runs under the condition that the rated voltage is much lower than the rated voltage in rural areas, and the current in the stator winding increases more, resulting in a higher temperature rise of the stator winding and overheating and burnout .
3. The quality factor in the manufacturer or repair, the quality factor in the manufacturer and repair causes the submersible pump to be overloaded.
4. The 60 rpm dc motor manufacturer tells you that there is a mechanical failure, the motor bearing is seriously damaged, the stator and the rotor are rubbed "sweeping" or the pump impeller is stuck by other debris such as water plants, etc., which will cause the motor stator winding to burn out. .
The 60 rpm dc motor manufacturer tells you that the content explained in the article is the cause of the overload of the DC gear motor. In order to ensure the high-efficiency performance of the equipment, it is necessary to strengthen the maintenance and repair of the equipment during use. You can follow the explanation in the article. The content of the general operation practice, I hope the content explained in the text will be helpful to everyone.